Peppers Cable Glands Ltd. Stanhope Road Camberley GU15 3BT ...
Tighten the compression nut of the cable entry gland. The seal ring must completely encircle the cable. 9. Unscrew the blind plug on the Primary, screw in ...
Bimed-2016.pdf1 Split gland as shown. 2 Fit Entry Body, allowing for any installation accessories, and fully engage the thread into the equipment. Hand-tighten, then suitably. Installation Overview - CiscoThe M12 nut must be tightened with a tightening torque from 0.6 Nm (hand- tight) to 1.5 Nm (using a torque wrench). An excessive tightening can damage the M12 ... Ex-e/i Cable Glands - MaluxStep 5. Assemble the mounting arm to the flanges. Use a wrench to tighten all screws and nuts. Step 6. Ensure that the antenna cannot rotate about the mast.
Autres Cours:
